The review will have to wait, as my Pixma Pro-1 is broken. Something is wrong with the paper feed as I am getting scraping down various kinds of paper. 285, 310 & 325 GSM paper are all showing the issue. The obvious cleaning and maintenance has been performed, and the issue is not improving. I have also attempted manual feed and rear feed, and that isn’t changing the outcome either.
Canon Pixma Pro-1 Review Sneak Peek
I have finally received my Canon Pixma Pro-1 A3+ printer, and an extra ink set. I’m very excited to get some printing done with it this weekend. This is a bit of a sneak peak, as I’ll work on the full review as I work with it this weekend.
Bring a friend to the store if you’re going to pick one up. The box is huge and it must weigh 80lbs. It’s probably the largest and heaviest A3+ printer ever made.
The printer itself is quite nice to look at it, very clean and looks extremely well built. Could a printer be beautiful? This one may be.
The box is packed nice and tidy and it was easy to get out and onto a table, or desk. The initial setup was a breeze, and the printer appears to be relatively quiet. The ink cartridges are pretty large for an A3+ printer and are very well built. I paid $400 for a set of 12 ink cartridges, I have no idea if that’s good until we get into how much ink the printer will use. I always found the Pixma 9500 Mark II to be ink hungry, or the cartridges too small. I always had to have lots of backups if I got into a weekend print session.
I will spend the next couple of days playing around and will have a full review ready to go Sunday night (pressure or what?).25 Comments