« on: August 26, 2012, 05:01:42 PM »
have you tried if its just the screen?
can you change settings when its in say p-mode?
To find out you could get it to green-mode, go to menu turn off the Beep, then turn to p-mode, ant then hit menu, set, turn dial press set. And when it beeps I think you could install it blind.
It's definitely not the screen, it works fine in both the auto modes, and if I take a picture in P mode, AV or whatever the picture can be viewed if I go back to either of the two auto modes.
There must be something inside the firmware that has gone aray I would assume as EOS says busy, I was shooting a continuous burst when it packed in, in raw.
It's still useable as an auto camera, but that's not how I shoot, and without display I can't set up my customs..
Yes its not the screen hardware. But in the customs is there just the output not working or does it go deeper and the camera is realy doing nothing. Because if its just the output then you would be able to reinstall the firmware by doing it blind.
Once I go beyond autos, all buttons appear to not function, I also can adjust by wheel, but without the screen, and without the custom menus appearing in auto modes how can I do it blind. If you have it stepped out I will try... nothing to lose..
Thanks, traveling home soon I will try when I get there if you would like to post