November 01, 2014, 10:11:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - MxM

Pages: [1]
1
What would you like to see in a future firmware update as an global add-on? I'm not talking ML here!!

I would like to see:
- An intervalometer
- The possibility to use the LED at the front of the camera grip as a Focus Assist LED


2
EOS Bodies - For Stills / Post your 'Noise by Ten' results
« on: September 12, 2014, 07:28:20 AM »
Yesterday I was al little bit bored and try the 'Noise by Ten' test.

- Set your body on a tri-pod and select manual mode
- Cover eyecup with piece from neckstrap
- Put on your lenscap
- Set your lens at manual focus
- Aperture f/10
- ShutterSpeed 10 seconds
- ShutterDelay 10 seconds
- Put your setup in the darkest place possible
- Run all ISO modes

Body: Canon 5D Mark III
Lens: Canon 50/1.4


As you can see are ISO160 and ISO320 cleaner then ISO100. Even ISO640 is cleaner then ISO400
More noise is a bigger file and numbers don't lie. ;)

What are your results?



3
  • Open Reikan FoCal
  • Select Camera
  • Run Target Setup according to distance chart published below (click find target in target setup to verify distance)
  • Run Aperture Sharpness Test (leave everything default)
  • Save Report
  • Publish Page 2 from the report (720px height)

FoCal Test Distance Chart:
https://dl.dropbox.com/u/11469157/FoCal/Docs/FoCal%20Test%20Distance_1.0.pdf

Canon 7D + Sigma 14mm f/2.8 EX Aspherical HSM = 3373,5


Pages: [1]