October 25, 2014, 06:24:21 PM

Author Topic: 3D Printed Lightboxes Mounted on Canon 100mm 2.8 Macro  (Read 544 times)

U-Type

  • SX60 HS
  • **
  • Posts: 8
    • View Profile
    • Design Portfolio
3D Printed Lightboxes Mounted on Canon 100mm 2.8 Macro
« on: February 24, 2014, 05:49:23 PM »
Hey everyone, this is a project I've been working on for the past few weeks.

These are LED Lightboxes mounted on Canon 100mm 2.8 Macro made from 3D printing.
Prototype version 1.0, LEDs are working at 2/3 power.

Total work time about 20 hours, including initial ideation, modelling, refinements, painting, cutting, assembling electronics, testing.

Video recording and editing also done by myself.

Check out the video below!
https://vimeo.com/87435981
« Last Edit: February 24, 2014, 05:59:18 PM by U-Type »
5D Mark III, 7D, 350D | http://utypedesign.com/

canon rumors FORUM

3D Printed Lightboxes Mounted on Canon 100mm 2.8 Macro
« on: February 24, 2014, 05:49:23 PM »

Drizzt321

  • 1D X
  • *******
  • Posts: 1674
    • View Profile
    • Aaron Baff Photography
Re: 3D Printed Lightboxes Mounted on Canon 100mm 2.8 Macro
« Reply #1 on: February 24, 2014, 05:56:07 PM »
Nifty. Are you going to publish a full list of parts & diagrams as well as the 3-D model file?
5D mark 2, 5D mark 3, EF 17-40mm f/4L,  EF 24-105mm f/4L IS USM, EF 135mm f/2L, EF 85mm f/1.8
Film Cameras: Mamiya RB67, RB-50, RB-180-C, RB-90-C, RB-50, Perkeo I folder, Mamiya Six Folder (Pre-WWII model)
http://www.aaronbaff.com

canon rumors FORUM

Re: 3D Printed Lightboxes Mounted on Canon 100mm 2.8 Macro
« Reply #1 on: February 24, 2014, 05:56:07 PM »