Hey everyone, this is a project I've been working on for the past few weeks.
These are LED Lightboxes mounted on Canon 100mm 2.8 Macro made from 3D printing.
Prototype version 1.0, LEDs are working at 2/3 power.
Total work time about 20 hours, including initial ideation, modelling, refinements, painting, cutting, assembling electronics, testing.
Video recording and editing also done by myself.
Check out the video below!
https://vimeo.com/87435981
These are LED Lightboxes mounted on Canon 100mm 2.8 Macro made from 3D printing.
Prototype version 1.0, LEDs are working at 2/3 power.
Total work time about 20 hours, including initial ideation, modelling, refinements, painting, cutting, assembling electronics, testing.
Video recording and editing also done by myself.
Check out the video below!
https://vimeo.com/87435981
