March 06, 2015, 04:29:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - bloodstupid

Pages: [1] 2 3
Site Information / is there a news feed without the advertising?
« on: November 30, 2013, 02:42:56 AM »
In the early days it was all about rumors, new releases and firmware updates.

Today i have the feeling its all about prices of canon gear (lenses, bodys, memorycards etc.). I am not only talking about that BlackFriday stuff (which i of course dont care at all too). Its going on for a while now.

I really dont care for how much this stuff sells where you live, i probably wouldnt even care if i lived on the same continent.

So is there a rss feed version without those advertisements?

Software & Accessories / Re: Any news about DPP4
« on: December 16, 2012, 07:52:11 AM »
I hope it will finally allow to apply the lens correction settings to all photos at once ..if you do it now all photos get corrected with the distance settings of the first photo.

Software & Accessories / Re: Any news about DPP4
« on: December 16, 2012, 07:40:46 AM »
Yes, i dont remember where..maybe here or somewhere else..but i read somewhere that a completly redone version would be coming by the end of 2012.

Software & Accessories / Any news about DPP4?
« on: December 16, 2012, 03:37:38 AM »
Are there anything new about DPP4 wich was supposed to be released by the end of the year?

EOS Bodies / Re: Canon EOS 5D Mark III Blinking Red AF Point Information
« on: November 15, 2012, 01:27:48 PM »
You are missing the point.  go back and reread the original article.  It messes up the metering.  BTW, metering is done when you press the shutter button.
I'd much rather have a properly metered image than the red AF point if I had to make a choice.

I'm not and the shutter button isnt my AF start button. It would be easy to pause the light metering for this one short location blink of the AF point.

At any rate, that would only work for the first shot - you still wouldn't know where the AF points would move for the 2nd, 3rd, ... shot. Which is the actual issue, because the red-flare-on-focus *is* available in One Shot mode (and we all set the DOF button to toggle between One Shot and AI Servo. Right? Right?). So don't oversimplify either ;)

I dont care, i just dont want it to be a step backwards from the 5D II, i would be happy with the same funcionality if more cant be done. But less is just not an option.

EOS Bodies / Re: Canon EOS 5D Mark III Blinking Red AF Point Information
« on: November 15, 2012, 11:46:37 AM »
WTF, then just give us a short AF blink when the AF-On button is pushed. Just like it was with the MarkII. At least it would be on the same level then. No reason to make this more complicated as it is.

EOS Bodies / Re: 5D Mark III Firmware?
« on: October 09, 2012, 09:07:29 AM »
Any news on this?

EOS Bodies / Re: AF Point Color on the 5D Mark III & 1D X Update [CR2]
« on: September 05, 2012, 05:22:09 AM »
Anything new about when we will be getting our firmware update?

For me personally the function like the 5D2 would be enough. I dont need it on all the time..especially if it cant be done without the light affecting measurements. Just have it the way it was before and i'm happy.

All that matters is the "highlight tone priority" because this pushes the shadows while recording your image and cant be undone in RAW.

You probably did but id better ask to be sure. Did you disable the "highlight tone priority", this improves noise in the dark areas.

EOS Bodies - For Stills / Re: 5D2 vs 5D3 low light AF
« on: June 20, 2012, 01:54:34 AM »
Would it make sense to let it only use the crosstype sensors? Or should i have them both actived?

It does not affect metering it affects the sensor.

Most of the time you take your photos with the rubber cover on the connectors anyway. But if you have a remote plugged it it can be trouble.

Sorry, i dont own it anymore.

Pages: [1] 2 3