Loose grip on 1DX?

[donkbet45]

Hi, I noticed today that the grip on the bottom of my 1DX is a little loose. It's not bad and I'm unsure if it has always been like that. Perhaps it's normal? I'm just a little concerned it could become worse. Is it normal for it to be a little loose in these 2 spots? Thanks

 

[Jim Saunders]

The rubber on mine on the aft edge there has a bit of a gap to the frame underneath. I'm not worried about it.

Jim

 

[donkbet45]

The rubber on mine on the aft edge there has a bit of a gap to the frame underneath. I'm not worried about it.

Jim

Thank you Jim. Gives me some peace of mind. I`m always OCD when it comes to my camera gear, especially the expensive stuff.

 

[donkbet45]

Anyone else?

 

[wickidwombat]

put a RRS L bracket on and never take it off and you will never notice it again

 

[Jim Saunders]

put a RRS L bracket on and never take it off and you will never notice it again

Does the RRS bracket go that far? I have the Kirk one and it stops about a half inch short of that area.

Jim

 

[wickidwombat]

does on previous 1D bodies and has a cast in strap mounting point to replace it I am guessing the X would be no different

edit

Looks like not

http://www.reallyrightstuff.com/s.nl/it.A/id.2106/.f