Hi everybody!
I have noticed that the central part of the top plate around the hot shoe ( it covers wi-fi modules, hyroscope etc) is slightly wobbly at the far edges and does not fit tight with the rest of the top plate near the lens mount ( its edges protrude slightly above the rest of the plate around 0,5 mm). I can press it by the sides with fingers and see how it plays a bit. I have attached a photo, where I circled the slightly protruding part ( the photo shows the plate from one side only, but the other side is the same). I have asked CPS and they say that it is normal. I, however, doubt it and am afraid of potential sealing issues.
I would kindly ask the r5 owners to check if their plates are the same. Please check before you say "zero play in mine" ) ( there are always people who say about zero play, when there is obvious play due to construction like with the IBIS rattle of stabbed lenses and bodies)
Thanks!
I have noticed that the central part of the top plate around the hot shoe ( it covers wi-fi modules, hyroscope etc) is slightly wobbly at the far edges and does not fit tight with the rest of the top plate near the lens mount ( its edges protrude slightly above the rest of the plate around 0,5 mm). I can press it by the sides with fingers and see how it plays a bit. I have attached a photo, where I circled the slightly protruding part ( the photo shows the plate from one side only, but the other side is the same). I have asked CPS and they say that it is normal. I, however, doubt it and am afraid of potential sealing issues.
I would kindly ask the r5 owners to check if their plates are the same. Please check before you say "zero play in mine" ) ( there are always people who say about zero play, when there is obvious play due to construction like with the IBIS rattle of stabbed lenses and bodies)
Thanks!
Attachments
Last edited: