New EdMika FDn-EOS mount swap kit launch. It fits more than one lens!

Status
Not open for further replies.
ontarian said:
Mr Bean said:
Any chance of the FD 20mm f2.8 fitting an EOS mount?

Because the iron ring on the 20 2.8 is missing screws and holes it would be extremely difficult. I'm working with Jim Buchanan (world famous lens conversion services specialist) on some stuff and perhaps he could overcome this issue with a soldered on solution. People would have to send their lenses in to him for the adaptation though.
Okay, thanks ontarian.
 
Upvote 0
I just finished converting my old FD 50mm 1.4 to an EF mount using the new EdMika Canon FDn-EOS adapter kit. http://www.ebay.ca/itm/170911278282?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649#ht_2239wt_1344

The conversion process is quite easy to do for the average person but you really should watch the how-to video first. EdMika FDn-EOS kit instructions The video is 12:21 and that is about how long it took me to do the entire conversion.

The kit consists of a really nice precision machined brass mount (fitted with a black sleeve to prevent light scattering) and a small machined peice of brass that is used to engage the aperture control after the old mount is removed. The mount comes equipped with a "Dandelion" fully programable Auto-Focus confirmation chip. Also included is a EF lens cap.

Here are some photos of the lens after conversion to the EF mount. There is a small indentation for a "lens Mount Index". (mounting alignment mark). I dabbed a bit of red paint on it so it is easier to spot.

IMG_4806.jpg


IMG_4804.jpg


IMG_4800.jpg


IMG_4807.jpg


IMG_4823.jpg


IMG_4814.jpg
 
Upvote 0
Status
Not open for further replies.