sanj said:
Hello.
Is there something like 'sensor hours' before it goes bad? After a certain amount of clicks the shutter mechanism needs to be replaced but how about sensor?
Before video I am not sure if this mattered but now with so much video being shot on DSLR does the sensor go bad after a certain usage?
thx for any input!
Yes.. but not in a meaningful sense.
What you're talking about in silicon are processes like "electromigration", modern IC deisgn follows processes to mitigate this to an extent that it just doesn't happen.
Outside of silicon you have problems with solder aging, I've seen a fair few circuits die as the solder crumbles.
Either of these will eventually kill a camera. However the golden rule with ALL electronics is keep it cool and clean. Don't mount your TV over the fire, don't let a Hi-Fi get full of dust (dust is an insulator, so lets chips get hotter than designed) 100C is the key temperature, if the silicon itself operates beyond 100C for any length of time then lifetime halves for every 10C above that, I'm not aware of sensors getting anthing like that hot.
If your kit is kept cool and clean it should last a VERY long time.. I'm thinking at least a couple of decades, possibly much more.
Frankly your camera is massively more likely to die from shutter failure, damage from dropping, or fungus. To avoid fungus look up museum artifact protection. basically, keeping humidity below 50% RH, and at an even temperature, room temperature is fine.
So don't store your camera in your car, or in a damp cupboard.