• The Canon Rumors Forum has officially been shut down as of July 10, 2026.

    All data will be deleted on September 16, 2026.

    the ad free experience will return by July 17, 2026.

Canon 1DX maintenance?

Mar 31, 2012
1,672
0
15,881
112
US - Midwest
I've hit roughly 70,000 clicks on my 1dx and I'm wondering if it's about time to send it in for a clean and check? Is there a general recommendation/rule that I should be following?

I've recently started to notice my keeper rate is significantly down (shooting sports) and I'm wondering if a clean and check would help.

Thanks in advance for your help and advice!

north
 
Its not a bad idea to use your CPS clean and check coupons once a year. It seems more likely that a low keeper rate is lens related, so I'd have your most used lenses checked as well. Its the lens internals that move quickly during AF, there are a lot of things going on in the lens that can affect AF accuracy or consistency. Only the mirror/sub mirror and shutter is moving in the camera. The sub mirror can cause issues if it hangs up, but I'm not sure what the symptom would be.
 
Upvote 0
I've been wondering the same with my 5D3. I think I'm around 100k or so.

Problem is that there's never good time to send it out :( There's always something fun to shoot, so I cannot part with my camera...
 
Upvote 0
tpatana said:
I've been wondering the same with my 5D3. I think I'm around 100k or so.

Problem is that there's never good time to send it out :( There's always something fun to shoot, so I cannot part with my camera...

That's where CPS comes in - though I admit that it is very different from country to country (both in entry and service etc).
 
Upvote 0
I had mine in for cleaning and check after about 50k, primarily to clean the sensor. It turned out that the particles I had on the sensor was from a part that was wearing down. Apparently a known fault, which had slipped my attention. Everything was fixed and I probably have another 50k exposures now and the camera still performs as new.
 
Upvote 0
Eldar said:
I had mine in for cleaning and check after about 50k, primarily to clean the sensor. It turned out that the particles I had on the sensor was from a part that was wearing down. Apparently a known fault, which had slipped my attention. Everything was fixed and I probably have another 50k exposures now and the camera still performs as new.

That part that's wearing down I believe is the reason why particles also continually get thrown up into the viewfinder of the camera.
 
Upvote 0