Seems to me each time I turn this printer on, it cycles thru about a minute or longer "getting ready" ... then, when I hit the print button, it seems to do it all over again before the print will begin.
Then, when I start another print, it seems the print cage runs thru an entire process again, sounds like it's printing on the bed - almost like a cleaning cycle. THEN finally, it prints the image. But it shouldn't do a "cleaning cycle", if that's what it's doing, between each print.
Does this seem right to you all? I'd think it would cycle once when you turn it on, and then print with a minimal cycle time between prints.
I'm using all Canon products - both print containers and ink -- not refills, just new cartridges every time I run out of a color.
Then, when I start another print, it seems the print cage runs thru an entire process again, sounds like it's printing on the bed - almost like a cleaning cycle. THEN finally, it prints the image. But it shouldn't do a "cleaning cycle", if that's what it's doing, between each print.
Does this seem right to you all? I'd think it would cycle once when you turn it on, and then print with a minimal cycle time between prints.
I'm using all Canon products - both print containers and ink -- not refills, just new cartridges every time I run out of a color.