• The Canon Rumors Forum has officially been shut down as of July 10, 2026.

    All data will be deleted on September 16, 2026.

    the ad free experience will return by July 17, 2026.

Help needed: 24-105 f4 L softness and very stiff lens hood mount

Status
Not open for further replies.
So, at last - here's an update. We've had some very bad weather 'round here the last few days so I did't have any opportunity to test the lens with natural light as proposed.

First of all, thank you all for your help and your suggestions. I repeated the process outside (didn't have much time til it started raining again) with the following results:

- first of all: the results were a lot better for the 24-105 under these conditions (seems the 70-300mm didn't suffer as much from the suboptimal conditions last time)
- at the long end the lens is still not excellent, noticeably worse than the 70-300L@100mm and much worse than it is @24 to 35mm.
- at the short end the lens is quite good, even slightly better than the 70-300L
- af ist quite spot-on most of the time

After all I've read, I think this is quite how this lens is expected to perform - so I'm happy and I'll continue shooting other things than resolution targets :D.

And btw: a little skin oil really helped the hood. It's still stiff and not very smooth running, but it is okay for me now.

Here is how I tested:

- Outside, ISO 100 ~1/300s-1/500s, f4
- IS off
- no filter
- Sturdy heavy tripod
- EOS-Utility attached to my laptop, LiveView with maximum magnification
- Distance to Object ~25 times the focal length to keep the target size consistent (target was about the size of the center viewfinder circle)
- Used only the very center to judge the sharpness
- MF and AF (to review the results of my afma settings obtained last time)

- focussed manually using the Liveview on the Laptop and did some Photos.
- with "AF on" I checked if I could improve things by overriding the focus manually (which hardly was the case).
- took some Photos using AF only (for comparison)
- tried to optimize the results using the AF-controls of the EOS-Utility (focus to infinity, phase AF, correct step-wise and count, repeat, feed the result back to afma)

After trying both the manual (operating the af ring by hand) and the AF+EOS-Utility (operating the AF step-wise by software) approach to afma, I think the latter is quite a bit easier/faster to do and yields very similar results.
 
Upvote 0
Status
Not open for further replies.